铅酸蓄电池固化室必须满足的条件

① 采用电热或热源，确保固化过程温度可控； ② 采用湿源（发出蒸汽）确保相对湿度能在100 % -O 变化；③ 堆放生极板的叠板架。 固化与干燥两个过程工艺要分开，对于涂膏后的极板，干燥早期可能还会有一点固化过程；而在固化过程几乎没有一点干燥过程。固化有助于在与铅青接触的板栅表面形成腐蚀层（结合层），它还能使铅膏中游离铅含量降至最低（3 ％以下），并且在控制温度与湿度下确立3BS-4BS 平衡体系的建立。 ①Adopt an electricity hot or hot source, ensure that the temperature that is solid to turn process can control; ②Adopting a wet source(send out steam) ensures that the relative humidity can change in 100%-O;③Pile to living pole knothole to fold a plank. Is solid to turn to want with two dry process crafts to separate, for the pole plank after applying ointment, the aridity was probably also a little bit solid to turn process in early days;But almost have no a little dry process in the process of being solid to turn.Is solid to turn to contribute to at and the plank grid surface formation corrosion layer(combine a layer) of lead green contact, it can also make to visit to leave a lead content to decline to in the lead cream lowest(below 3%), and establish the establishment of 3 BS BSs-4s equilibrium system while controling temperature and degree of humidity.